Signal Logic Circuits
Signal Logic connects sensors and devices through gates such as AND, OR, XOR, inverter, and delay for more complex automation.
Signal Logic extends the Trigger and Sensor system and allows more elaborate connections between several inputs and devices. Open it with the SIGNAL LOGIC button at the top of the Control Panel.
Purpose
Signal Logic supports configurations that the standard signal drop-down lists cannot create, such as combining multiple Sensors to control several devices.
Setup
- Place Sensors on the structure.
- Access each Sensor directly or through the Control Panel and assign a unique signal name.
- Open SIGNAL LOGIC and create a circuit.
- Select an input signal on the left.
- Enter a name for the output signal on the right.
- Open the devices controlled by the circuit and select the output signal in each device's signal drop-down list.
Logic gates
- AND: Sends the output only when every input Sensor is active. With two Trigger Plates, for example, a Light turns on only when both Plates are occupied.
- OR: Sends the output when one or more input Sensors are active. A Light turns on when either Plate, or both Plates, are occupied.
- XOR: Sends the output when exactly one of two inputs is active. It does not trigger when both are active.
- INVERTER: Reverses the signal, such as converting On to Off. It can switch a Light off when a Plate is activated and can also normalize inputs before an AND gate.
- SET/RESET Latch: Uses two Sensors, with one setting the output and the other resetting it.
- DELAY: Delays a single signal by the number of seconds entered in the button field.
Circuit outputs can be used as inputs for additional circuits. This allows complex logic chains. Do not delete an underlying circuit that supplies an output required by another circuit, or the chain will stop working.
See also
Updated 2026-07-27