Sensor Setup and Modes
Configure Follow or Toggle behavior to make sensors activate, open, close, lock, or unlock compatible devices.
Basic Triggers and Sensors can activate, deactivate, open, close, lock, or unlock connected devices. Available actions depend on the functions supported by each device. More advanced circuits are available through Signal Logic.
Signal modes
- FOLLOW
- Lever: The device follows the Lever position. On produces On, and Off produces Off.
- Sensor: Entering the detection area produces On; leaving it produces Off.
- TOGGLE
- Lever: Not recommended because the handle may need to be moved twice before the desired effect occurs.
- Sensor: Each entry into or exit from the detection area reverses the device state from On to Off or from Off to On.
- ON or OFF
- Lever: Not useful for this mode.
- Sensor: Sets the device to a specific On or Off state without considering its previous state. Repeated activation has no further effect until the state changes elsewhere.
Setup example
- Place a Trigger, such as a Trigger Plate.
- Face the Trigger Plate and press P.
- When the Trigger Plate is selected in the Control Panel, locate the Tx Signal field below the device list.
- Enter 'TEST' and confirm.
- Place a Light.
- Face the Light and press P.
- When the Light is selected, its On/Off controls display two drop-down lists and an Invert checkbox marked 'I' below the device list.
- Open the first drop-down list and select the TEST signal to connect the Light to the Trigger Plate.
- Open the second drop-down list and choose FOLLOW, TOGGLE, ON, or OFF.
- Use ON or OFF to force the Light into that state when the Plate is triggered.
- Use TOGGLE to reverse the Light's current state.
- Use FOLLOW to keep the Light active only while a player stands on the Plate.
- Use FOLLOW with INVERT to dim or deactivate the Light while a player stands on the Plate.
See also
Updated 2026-07-27